|PCMCIA(4)||Device Drivers Manual||PCMCIA(4)|
— introduction to PCMCIA (PC Card)
pcic0 at isa? port 0x3e0 iomem 0xd0000 iosiz 0x10000
pcic1 at isa? port 0x3e2 iomem 0xe0000 iosiz 0x4000
pcic2 at isa? port 0x3e4 iomem 0xe0000 iosiz 0x4000
pcic* at isapnp?
pcic* at pci? dev?
pcmcia* at pcic?
tcic0 at isa? port 0x240 iomem 0xd0000 iosiz 0x10000
pcmcia* at tcic?
pcic0 at cbus? port 0x3e0 iomem 0xd0000 iosiz 0x10000
pcmcia* at pcic?
stp* at sbus?
pcmcia* at stp?
# all architectures
cbb* at pci?
cardslot* at cbb? flags 0x0000
pcmcia* at cardslot?
pcmcia subsystem provides
machine-independent bus support and drivers for PCMCIA (PC Card)
OpenBSD provides support for the following devices. Note that not all architectures support all devices.
The supported PCMCIA controllers are those that are i82365 compatible.
pcmcia adapters, for instance the
bus will be mapped in big-endian format instead of the natural (and
preferred) little endian format. Unfortunately such controllers lack the
hardware facility to swap bytes, and it is not efficient to convert all
drivers to always know about this. While 8 bit drivers can invisibly work on
such a bus, 16 bit drivers will need modification to handle this. So far,
wi(4) is the only driver to require these
pcmcia adapter is not detected, or
pcmcia events (such as card insertion) do not
occur, there may be a PCI card BIOS mapped in the same memory space the
pcmcia driver is configured to use (this is often
the case with Ethernet card boot ROMs). The output from
dmesg(8) should contain a line beginning
with “bios0” that lists the memory address and size of mapped
regions. If there is a conflict, you can use
boot_config(8) to change the iomem
parameter of the pcic device to a non-overlapping address,
such as 0xd8000 for pcic0. Some experimentation may be
required to find a working value; in some cases the size parameter of the
pcic device may need to be decreased to avoid a
pcmcia driver appeared in
|June 30, 2019||OpenBSD-current|