OpenBSD manual page server

Manual Page Search Parameters

GETTY(8) System Manager's Manual GETTY(8)

gettyset terminal mode

getty [type [tty]]

The getty program is called by init(8) to open and initialize the tty line, read a login name, and invoke login(1).

The argument tty is the special device file in /dev to open for the terminal (for example, ``ttyh0''). If there is no argument or the argument is ‘-’, the tty line is assumed to be open as file descriptor 0.

The type argument can be used to make getty treat the terminal line specially. This argument is used as an index into the gettytab(5) database, to determine the characteristics of the line. If there is no argument, or there is no such table, the table is used. If there is no /etc/gettytab a set of system defaults is used. If indicated by the table located, getty will clear the terminal screen, print a banner heading, and prompt for a login name. Usually either the banner or the login prompt will include the system hostname.

Most of the default actions of getty can be circumvented, or modified, by a suitable gettytab(5) table.

The getty program can be set to timeout after some interval, which will cause dial up lines to hang up if the login name is not entered reasonably quickly.

getty is started by init(8), with a process priority, umask, and resource limits based on the “default” entry in /etc/login.conf.

/etc/gettytab
 

ttyxx: No such device or address.
ttyxx: No such file or address.
A terminal which is turned on in the ttys(5) file cannot be opened, likely because the requisite lines are either not configured into the system, the associated device was not attached during boot-time system configuration, or the special file in /dev does not exist.

login(1), ioctl(2), tty(4), gettytab(5), login.conf(5), ttys(5), init(8)

A getty program appeared in Version 6 AT&T UNIX.

May 31, 2007 OpenBSD-5.1