parse and load file of spammer
spamd-setup utility sends blacklist
data to spamd(8), as well as configuring mail rejection messages for
spamd-setup is run in blacklist only
mode, it also sends blacklist data to the
<spamd>. The <spamd>
table must then be used in conjunction with a
rule to selectively redirect mail connections to
The options are as follows:
- Blacklisting only mode. Blacklist data is normally stored only in
With this flag, data is stored in both
and pf(4). Use
this flag if spamd(8) is running with the
- Daemonize; run
spamd-setupin the background.
- Debug mode reports a few pieces of information.
- Dry-run mode. No data is shipped.
Lists are specified in the configuration file /etc/mail/spamd.conf and are processed in the order specified in the all tag. Output is concatenated and sent to a running spamd(8). Addresses are sent along with the message spamd will give on mail rejection when a matching client connects. The configuration port for spamd(8) is found from services(5), by looking for the named service spamd-cfg.
spamd-setup reads all configuration
information from the
pf.conf(5), services(5), spamd.conf(5), spamd(8)
Blacklists removed from /etc/mail/spamd.conf are not automatically removed from the running spamd(8). If an entry is removed from /etc/mail/spamd.conf that is currently in use, it is necessary to restart spamd(8). This applies only to blacklists that are removed entirely, not those that are simply modified.