[OpenBSD]

Manual Page Search Parameters

SCHSIO(4) Device Drivers Manual SCHSIO(4)

NAME

schsioSMSC SCH311x LPC Super I/O

SYNOPSIS

schsio* at isa? port 0x2e flags 0x0000
schsio* at isa? port 0x4e flags 0x0000
schsio* at isa? port 0x162e flags 0x0000
schsio* at isa? port 0x164e flags 0x0000

DESCRIPTION

The schsio driver provides support for the SMSC SCH3112, SCH3114, and SCH3116 ICs. Among other things, the devices contain environment sensors, a watchdog timer, and fan control. The schsio driver supports the environment sensors and the watchdog timer.
The hardware provides the following sensors:
Sensor Units Typical use
Internal diode uK IC internal thermal diode
Remote diode 1 uK External thermal diode
Remove diode 2 uK External thermal diode
FAN1 RPM Fan tachometer
FAN2 RPM Fan tachometer
FAN3 RPM Fan tachometer
+2.5V uV Voltage
+1.5V (Vccp) uV Voltage
+3.3V (VCC) uV Voltage
+5V uV Voltage
+12V uV Voltage
+3.3V (VTR) uV Voltage
+3V (Vbat) uV Voltage
schsio provides the standard watchdog(4) interface and may be used with watchdogd(8). The watchdog timer may be configured to a value from 1 second to 255 minutes. The watchdog timer has a resolution of 1 second in the timeout interval 1 to 255 seconds. Outside this interval, the resolution is 1 minute.
Note that the pin used for signalling the timer expiration is configurable and may on some boards be intended for other uses than this. Because of this, the chip may not by default be configured to use the pin for watchdog operation. To force the schsio device to use the pin for watchdog operation, the driver may be configured with an autoconf(9) flags setting of 0x0001.

SEE ALSO

intro(4), isa(4), watchdog(4), sensorsd(8), sysctl(8), watchdogd(8), autoconf(9)

HISTORY

The schsio driver first appeared in OpenBSD 4.5.

AUTHORS

The schsio driver was written by Michael Knudsen <mk@openbsd.org>.
July 16, 2013 OpenBSD-current