OpenBSD manual page server

Manual Page Search Parameters

BGPLGSH(8) System Manager's Manual BGPLGSH(8)

bgplgshlooking glass shell for the OpenBSD Border Gateway Protocol daemon

bgplgsh

The bgplgsh program is a looking glass shell for the bgpd(8) Border Gateway Protocol daemon. The looking glass will provide a simple command line interface with read-only access to a restricted set of bgpd(8) and system status information, which is typically used on route servers by Internet Service Providers (ISPs) and Internet eXchange points (IXs).

It requires three steps to enable the looking glass shell:

  1. Add bgplgsh as a valid login shell. See shells(5) for more information.
    # echo /usr/bin/bgplgsh >> /etc/shells
  2. Create a new user for restricted looking glass access. See adduser(8) for more information about system user management.
    # adduser -shell bgplgsh -batch bgplg
    # passwd bgplg
  3. Start the Border Gateway Protocol daemon with a second, restricted, control socket. See bgpd.conf(5) and bgplg(8) for more information.

    For example, add the following to /etc/bgpd.conf to have bgpd(8) open a second, restricted, control socket:

    socket "/var/www/run/bgpd.rsock" restricted

/var/www/run/bgpd.rsock
Position of the second, restricted, control socket of bgpd(8).

bgpd(8), bgplg(8)

The bgplgsh program first appeared in OpenBSD 4.1. The initial implementation was done in 2005 for DE-CIX, the German commercial internet exchange point.

The bgplgsh program was written by Reyk Floeter <reyk@openbsd.org>.

To prevent commands from running endlessly, bgplgsh will kill the corresponding processes after a hard limit of 60 seconds. For example, this can take effect when using traceroute(8) with blackholed or bad routes.

March 17, 2019 OpenBSD-7.1