OpenBSD manual page server

NAME

ldattach — attach a line discipline to a serial line

SYNOPSIS

DESCRIPTION

ldattach is used to attach a line discipline to a serial line to allow for in-kernel processing of the received and/or sent data. Depending on the line discipline being attached, one or more options may be applied.

ldattach can be run from the command line or at system startup by having init(8) read ttys(5) entries to attach line disciplines.

The following options are available:

-2

Use 2 stopbits instead of 1.

-7

Use 7 databits instead of 8.

-d

Do not daemonize.

-e

Use even parity.

-h

Turn on RTS/CTS flow control. By default, no flow control is done.

-m

Maintain modem control signals after closing the line. Specifically, this disables HUPCL.

-o

Use odd parity.

-p

Pass the data received from device to the master device of a pty(4) pair and vice versa. The name of the slave device is written to standard output.

-s baudrate

Specifies the speed of the connection. If not specified, the default of 9600 baud is used (4800 baud for nmea(4)).

-t cond

nmea(4), msts(4) and endrun(4) line disciplines only. Chooses the condition which will cause the current system time to be immediately copied to the terminal timestamp storage for subsequent use by nmea(4), msts(4) or endrun(4). Only one can be used.

dcd

Copy the timestamp when DCD is asserted.

!dcd

Copy the timestamp when DCD is deasserted.

cts

Copy the timestamp when CTS is asserted.

!cts

Copy the timestamp when CTS is deasserted.

If no condition is specified, the nmea(4) line discipline will timestamp on receiving the leading ‘$’ character of each block of NMEA sentences.

discipline

Specifies the name of the line discipline to be attached.

endrun

Attach the endrun(4) line discipline.

msts

Attach the msts(4) line discipline.

nmea

Attach the nmea(4) line discipline.

device

Specifies the name of the serial line. device should be a string of the form “cuaXX” or “/dev/cuaXX”.

cua(4) devices should be used when ldattach is started from the command line; when started using init(8), tty(4) devices should be used.

If ldattach was not started by init(8), the line discipline can be detached by killing off the ldattach process.

EXAMPLES

To start ldattach using init(8) to attach the nmea(4) line discipline to /dev/tty01 at 4800 baud using a device without a carrier (DCD) line, add a line of the following form to /etc/ttys:

tty01	"/sbin/ldattach nmea"	unknown	on softcar

SEE ALSO

endrun(4), msts(4), nmea(4), pty(4), tty(4), ttys(5), init(8)

HISTORY

The ldattach command first appeared in OpenBSD 4.3.