sasyncd(8) - OpenBSD manual pages

NAME

sasyncd — IPsec SA synchronization daemon for failover gateways

The sasyncd daemon synchronizes IPsec SA and SPD information between a number of failover IPsec gateways. The most typical scenario is to run sasyncd on hosts also running isakmpd(8) or iked(8) and sharing a common IP address using carp(4).

The daemon runs either in master or slave mode, in which the master tracks all local IPsec SA changes and sends this information along to all slaves so they will have the same data.

When a slave connects, or reconnects, the master will transmit a snapshot of all its current IPsec SA and SPD information.

Failover

sasyncd does not itself do any failover processing; the normal mode of operation is to track state changes on a specified carp(4) interface. Whenever it changes, sasyncd will follow suit. For debugging purposes, it is possible to "lock" the daemon to a particular state; see sasyncd.conf(5).

sasyncd to sasyncd communication

As sasyncd will transmit IPsec SA key and policy information over a network not guaranteed to be private, sasyncd messages are protected using AES and SHA. The shared key used for the encryption must be specified in /etc/sasyncd.conf. See sasyncd.conf(5) for more information.

SA replay counters

For SAs with replay protection enabled, such as those created by isakmpd(8), the sasyncd hosts must have pfsync(4) enabled to synchronize the in-kernel SA replay counters. Without this replay counter synchronization the IPsec packets a host sends after failover will not be accepted by the remote VPN endpoint.

In most redundancy setups pfsync(4) is likely already activated to synchronize pf(4) states. See pfsync(4) for more information.

The options are as follows:

-c config-file: If given, the -c option specifies an alternate configuration file instead of /etc/sasyncd.conf.
-d: The -d option causes the daemon to run in the foreground, logging to stderr. Without this option, sasyncd sends log messages to syslog(3).
-n: Configtest mode. Only check the configuration file for validity.
-v: The -v option increases the verbosity level of the daemon, used primarily for debugging. This option may be specified several times.