|HOSTAPD(8)||System Manager's Manual||HOSTAPD(8)|
hostapdis a daemon which allows communication between different 802.11 wireless access points running in Host AP mode.
hostapdimplements the Inter Access Point Protocol (IAPP). Its purpose is to exchange station association updates between access points in large wireless networks. IAPP has been designed to speed up roaming between different access points in the same Extended Service Set (ESS). IAPP is described in the IEEE 802.11f standard.
hostapdadditionally allows the monitoring and logging of station associations on a non-hostap host which is receiving IAPP messages.
hostapduses two network interfaces on startup specified in the configuration file hostapd.conf(5). The first interface is used to access the Host AP, which is a wireless interface running in Host AP mode. Host AP mode can be enabled using ifconfig(8). The second interface is used to communicate with other
hostapdin the same broadcast domain or multicast group. Usually a wired interface is used to communicate with other
hostapdbroadcasts an ADD.notify IAPP message when a new station is associated to the Host AP. When
hostapdreceives an ADD.notify message it tells the Host AP to remove the specified station.
hostapdmay also handle dynamic roaming of IP addresses and routes in addition to the standard IAPP ADD.notify behaviour. See the section called IP Roaming in hostapd.conf(5) for details. The options are as follows:
hostapdprogram first appeared at the 21st Chaos Communication Congress (http://www.ccc.de/congress/2004/) and later in OpenBSD 3.8.
hostapdprogram was written by Reyk Floeter <firstname.lastname@example.org>.
hostapddepends on drivers using the net80211 kernel wireless layer with support of Host AP mode. For traditional reasons, the wi(4) driver still uses its own Host AP code in
if_wi_hostap(), which is not supported by
hostapd. The IEEE 802.11 WLAN protocol lacks authentication of management frames and is vulnerable to various Denial-of-Service and Man-in-the-Middle attacks. That should be considered when implementing wireless networks with
|July 16, 2013||OpenBSD-5.7|