OpenBSD manual page server

Manual Page Search Parameters

UPGT(4) Device Drivers Manual UPGT(4)

upgtConexant/Intersil PrismGT SoftMAC USB IEEE 802.11b/g wireless network device

upgt* at uhub? port ?

The upgt driver supports the USB 2.0 Conexant/Intersil PrismGT series wireless adapters based on the GW3887 chipset.

These are the modes the upgt driver can operate in:

BSS mode
Also known as mode, this is used when associating with an access point, through which all traffic passes. This mode is the default.
monitor mode
In this mode the driver is able to receive packets without associating with an access point. This disables the internal receive filter and enables the card to capture packets from networks which it wouldn't normally have access to, or to scan for access points.

The upgt driver can be configured to use Wired Equivalent Privacy (WEP) or Wi-Fi Protected Access (WPA-PSK and WPA2-PSK). WPA is the current encryption standard for wireless networks. It is strongly recommended that WEP not be used as the sole mechanism to secure wireless communication, due to serious weaknesses in it. The upgt driver relies on the software 802.11 stack for both encryption and decryption of data frames.

The upgt driver can be configured at runtime with ifconfig(8) or on boot with hostname.if(5).

The driver needs a firmware file which is loaded when an interface is brought up:


A prepackaged version of the firmware can be installed using fw_update(1).

The following adapters should work:

Belkin F5D7050 (version 1000)
Cohiba Proto Board
D-Link DWL-G120 Cohiba
D-Link DWL-G122 rev A2
FSC Connect2Air E-5400 USB D1700
Gigaset USB Adapter 54
Inventel UR045G
IOGear GWU513
Linksys WUSB54AG
Linksys WUSB54G ver 2
Medion MD40900
Philips CPWUA054
SMC EZ ConnectG SMC2862W-G
Sagem XG703A
Spinnaker DUT
Spinnaker Proto Board
Thomson SpeedTouch 121g

The following example scans for available networks:

# ifconfig upgt0 scan

The following hostname.if(5) example configures upgt0 to join network “mynwid”, using WPA key “mywpakey”, obtaining an IP address using DHCP:

nwid mynwid
wpakey mywpakey

arp(4), ifmedia(4), intro(4), netintro(4), usb(4), hostname.if(5), ifconfig(8)

The upgt driver first appeared in OpenBSD 4.3.

The upgt driver was written by Marcus Glocker <>.

The hardware specification was reverse engineered by the people at

The upgt driver just supports the USB 2.0 devices (GW3887 chipset) but not the USB 1.0 devices containing the NET2280, ISL3880, and ISL3886 chipsets. Some further efforts would be necessary to add USB 1.0 support to the driver.

February 15, 2014 OpenBSD-5.6