OpenBSD manual page server

NAME

gsc — introduction to HP 9000/700 GSC bus support

SYNOPSIS

gsc* at lasi?
gsc* at asp?
gsc* at wax?

DESCRIPTION

The General System Connect (GSC) bus is the core I/O bus for all HP 9000/700 workstations. All I/O subsystems connect to this bus. The devices can be either on separate chips, expansion cards or on an integrated megacell, like the LASI MBA.

The GSC bus is a 32-bit wide, address and data multiplexed bus. In its "standard" implementation it has a maximum throughput of 160MB/s, the "2x" implementation reaches up to 250MB/s. Some HPPA CPUs directly attach to this bus, namely the PA7100LC and PA7300LC.

As for the expansion cards, there are different form-factors, depending on bus-speed (standard or 2x) and specific models. The standard formfactor is the "EISA form-factor"; cards that look like typical EISA cards with a different connector (100-pin female EBBL). The Series 712 have their own special type of GSC expansion cards, called the "GIO form-factor", which is quite small and mostly has only one VLSI chip on it (in most cases LASI/WAX). Newer systems sometimes feature the "HSC formfactor", which is a 1U-VME card-like expansion card with a 100-pin male pin+socket connector. Mixing cards with different speeds is supported but downgrades the performance of the whole I/O-subsystem.

OpenBSD provides support for the following devices:

Some of these GSC devices also have PCI, EISA, or ISA equivalents. These are listed in pci(4), eisa(4), or isa(4).

SEE ALSO

asp(4), cpu(4), intro(4), lasi(4), wax(4)

HISTORY

The gsc driver appeared in OpenBSD 2.6.