ul reads the named files (or standard
input if none are given) and translates various kinds of in-band markup to
forms appropriate for the terminal in use, as specified by the environment
TERM and the
terminfo(5) database. In particular,
locale produce output
ul can handle as input.
The following control characters are handled in the input stream:
- backspace (ASCII 0x08)
- Reset the output display column to the beginning of the previous character, to prepare for overstriking. The display width of the previous character does not matter: backing up over a double-width character does not require two backspace characters. However, if a double-width character is followed by two backspace characters, the second one is discarded, for compatibility with fold(1).
- tabulator (ASCII 0x09)
- Advance the output display column to the next multiple of 8. Tabs are always expanded into blanks.
- newline (ASCII 0x0a)
- End the current output line.
- carriage return (ASCII 0x0d)
- Reset the output display column to the beginning of the line, to prepare for overstriking.
- shift out (ASCII 0x0e)
- Switch on reverse video mode.
- shift in (ASCII 0x0f)
- Switch off reverse video mode.
- escape 7 (ASCII 0x1b 0x37)
- Full reverse line feed.
- escape 8 (ASCII 0x1b 0x38)
- Half reverse line feed. Sometimes used for superscripts.
- escape 9 (ASCII 0x1b 0x39)
- Half forward line feed. Sometimes used for subscripts.
The following kinds of markup are handled:
- Requested by putting an underscore into the same display cell as another character, by using backspace or carriage return characters. The usual sequence to request an underlined character is "character backspace underscore", but "underscore backspace character" works, too. If the terminal cannot underline, standout mode is tried as a fallback.
- Requested by putting two copies of the same character into the same display cell, by using backspace or carriage return characters. The usual sequence to request a boldface character is "character backspace character". If the terminal does not provide boldface display, reverse video and standout mode are tried as fallbacks.
- reverse video
- Switched on and off by the shift out and shift in control characters, respectively. If the terminal does not provide reverse video, standout mode is tried as a fallback.
If the input text contains markup the terminal cannot handle and
no working fallback is available, that markup is ignored. Non-printable
characters and invalid bytes are discarded. Unknown escape sequences cause
ul to abort with an error message and a non-zero
The options are as follows:
- Markup is not applied. Instead, after each output line containing at least
one marked-up character, an additional line is printed, containing the
following ASCII codes below each character they apply to:
- inverse video
- one half line above the current line (superscript)
- one half line below the current line (subscript)
- more than one kind of markup
- Overrides the terminal type specified in the environment with terminal.
- The character encoding locale(1). It decides which byte sequences form characters, which characters are printable, and what their display width is. If set to "C", "POSIX", or an unsupported value, each ASCII character except the control characters listed above is regarded as a character, and if it is printable, of display width 1.
- Used to relate a tty device with its device capability description (see
TERMis set at login time, either by the default terminal type specified in /etc/ttys or as set during the login process by the user in their login file (see environ(7)).
ul utility exits 0 on success,
and >0 if an error occurs.
ul command appeared in
Half reverse and half forward line feeds only work on few terminals, and full reverse line feeds aren't very portable, either.
If more than one kind of markup is applied to the same character, all these markups are ignored and standout mode is used instead.