LGE(4) | Device Drivers Manual | LGE(4) |
lge
—
lge* at pci?
xmphy* at mii?
lge
driver provides support for various NICs based
on the Level 1 LXT1001 NetCellerator Gigabit Ethernet controller chip,
including the following:
These NICs are capable of 1000Mbps speeds over fiber optic cable. The LXT1001 also supports a GMII port for use with 10/100/1000 copper PHYs, however there aren't currently any NICs on the market that use this feature.
The LXT1001 supports IPv4 receive IP/TCP/UDP checksum offload as well as a 64-bit multicast hash filter. It also supports jumbo frames.
The lge
driver supports the following
media types:
autoselect
1000baseSX
full-duplex
and
half-duplex
modes are supported.The lge
driver supports the following
media options:
full-duplex
half-duplex
For more information on configuring this device, see ifconfig(8).
Level 1 LXT1001 Programming Manual, http://people.freebsd.org/~wpaul/Level1/LXT1001SRM.pdf.
lge
device driver first appeared in
OpenBSD 3.0.
lge
driver was written by Bill
Paul
<william.paul@windriver.com>.September 14, 2014 | OpenBSD-current |