OpenBSD manual page server

NAME

malo — Marvell Libertas IEEE 802.11b/g wireless network device

SYNOPSIS

malo* at cardbus?
malo* at pci?
malo* at pcmcia?

DESCRIPTION

The malo driver provides support for Marvell Libertas 88W8335/88W8310/88W8385 based PCI/CardBus/PCMCIA network adapters. The second generation 88W8335/88W8310 chipsets support 802.11b/g.

These are the modes the malo driver can operate in:

BSS mode

Also known as infrastructure mode, this is used when associating with an access point, through which all traffic passes. This mode is the default.

monitor mode

In this mode the driver is able to receive packets without associating with an access point. This disables the internal receive filter and enables the card to capture packets from networks which it wouldn't normally have access to, or to scan for access points.

The malo driver can be configured to use Wired Equivalent Privacy (WEP) or Wi-Fi Protected Access (WPA1 and WPA2). WPA2 is the current encryption standard for wireless networks. It is strongly recommended that neither WEP nor WPA1 are used as the sole mechanism to secure wireless communication, due to serious weaknesses. WPA1 is disabled by default and may be enabled using the option "wpaprotos wpa1,wpa2". For standard WPA networks which use pre-shared keys (PSK), keys are configured using the "wpakey" option. WPA-Enterprise networks require use of the wpa_supplicant package. The malo driver relies on the software 802.11 stack for both encryption and decryption of data frames.

The malo driver can be configured at runtime with ifconfig(8) or on boot with hostname.if(5).

FILES

The driver needs a set of firmware files which are loaded when an interface is brought up:

These firmware files are not free because Marvell refuses to grant distribution rights. As a result, even though OpenBSD includes the driver, the firmware files cannot be included and users have to download these files on their own.

A prepackaged version of the firmware can be installed using fw_update(8).

HARDWARE

The following cards are among those supported by the malo driver:

EXAMPLES

The following example scans for available networks:

The following hostname.if(5) example configures malo0 to join network “mynwid”, using WPA key “mywpakey”, obtaining an IP address using DHCP:

join mynwid wpakey mywpakey
inet autoconf

SEE ALSO

arp(4), cardbus(4), ifmedia(4), intro(4), netintro(4), pci(4), hostname.if(5), ifconfig(8)

HISTORY

The malo driver first appeared in OpenBSD 4.1.

AUTHORS

The malo driver was written by Claudio Jeker and Marcus Glocker.

CAVEATS

WPA encryption is not supported for PCMCIA devices.

This driver does not support powersave mode.