OpenBSD manual page server

Manual Page Search Parameters

FDFORMAT(1) General Commands Manual FDFORMAT(1)

fdformatformat floppy disks

fdformat [-nqv] [-c cyls] [-F fillbyte] [-g gap3len] [-h heads] [-i intleave] [-r rate] [-S secshft] [-s secs] [-t steps_per_trackdevice_name

fdformat formats a floppy disk at device device_name. device_name should be a character device; it may be given either with a full path name of a raw device node for a floppy disk drive (e.g., /dev/rfd0c), or default name in an abbreviated form, (e.g., ). Note that any geometry constraints of the device node (minor device number) are meaningless, since they're overridden by fdformat.

The options are as follows:

cyls
Number of cylinders (40 or 80).
fillbyte
Use fillbyte as fill byte.
gap3len
Length of gap at the end of any sector (“gap 3”).
heads
Number of floppy heads (1 or 2).
intleave
Sector interleave to be used.
Don't verify floppy after formatting.
Suppress any normal output from the command, and don't ask the user for confirmation whether to format the floppy disk at device_name.
rate
Data transfer rate in kilobyte/sec (250, 300, or 500).
secshft
Sector size code: 0 for 128, 1 for 256, and 2 for 512 byte sectors.
secs
Number of sectors per track (9, 10, 15, or 18).
steps_per_track
Number of steps per track. An alternate method to specify the geometry data to write to the floppy disk.
Don't format; verify only.

If the -q flag has not been specified, the user is asked for confirmation of the intended formatting process. In order to continue, an answer of “y” must be given.

An exit status of 0 is returned upon successful operation. Exit status 1 is returned on any errors during floppy formatting, and an exit status of 2 reflects invalid arguments given to the program (along with appropriate information written to diagnostic output).

Unless -q has been specified, a single letter is printed to standard output to inform the user about the progress of work. First, an “F” is printed when the track(s) is being formatted, then a “V” while it's being verified, and if an error has been detected, it will finally change to “E”.

fdc(4)

fdformat was developed for 386BSD 0.1 and upgraded to the new fdc(4) floppy disk driver. It later became part of FreeBSD 1.1, and was then ported to OpenBSD 1.2.

The program was contributed by Joerg Wunsch, Dresden, with changes by Serge Vakulenko and Andrew A. Chernov, Moscow.

September 17, 2018 OpenBSD-7.5