OpenBSD manual page server

Manual Page Search Parameters

FDC(4) Device Drivers Manual FDC(4)

fdcNEC765 compatible floppy disk driver

fdc0 at isa? port 0x3f0 irq 6 drq 2 (alpha, amd64, i386)
fdc* at sbus? (sparc64)
fd* at fdc? flags 0x00

The fdc driver supports the standard AT floppy disk controllers. These include standard IDE, MFM, RLL, EIDE, ESDI and SCSI controllers with floppy attachment, commonly encountered on many isa bus machines, as well as the on-board floppy controller found on most UltraSPARC workstations.

The standard names of a floppy drive will take the form /dev/fd{0,1,2,3}{,B,C,D,E,F,G,H}[a-p].

The first component of this path is the unit number, permitting a total of 4 floppy drives. The next component is missing for the default geometry (it would be A, but it is omitted for simplicity) and B-H for the other 7 geometry types the floppy driver supports. The last component of the path is the 16 partitions that a floppy disk can support.

The additional geometry types are as follows:

`B' 1.44MB
 
`C' 1.2MB
 
`D' 360KB/AT (360KB disk in a 1.2 MB drive)
 
`E' 360KB/PC (360KB drive)
 
`F' 720KB
 
`G' 720KB/x (720KB in a 1.2 MB drive)
 
`H' 360KB/x (360KB in a 720KB drive)
 

The default geometry is the format specified in the BIOS, and is typically the largest supported format.

Some isa floppy controllers do not respond correctly to probes, and the configuration file flags field can be used to specify a particular drive type, overriding the probed type. If the 0x10 bit is on, the low order three bits of the flags field encode the drive type, as follows:

1 2.88MB
 
2 1.44MB
 
3 1.2MB
 
4 720K
 
5 360K
 
6 1.2 MB Japanese format
 

If the 0x20 bit is on, the drive will be attached even if it was not found by the probe routine. These flags are ignored on fdc controllers not connected to an isa(4) bus.

eject(1), fdformat(1), ebus(4), intro(4), isa(4), sbus(4)

The fdc driver can interfere with other isa(4) controllers, namely some WD/SMC network controllers fail to work when the probing mechanism in the fdc driver probes for a missing second floppy drive. In this case you should try recompiling the kernel replacing the relevant line with fd0 at fdc?.

September 1, 2016 OpenBSD-7.1