|WSMOUSE(4)||Device Drivers Manual||WSMOUSE(4)|
wsmouse — generic
mouse support in wscons
wsmouse* at ...
wsmouse driver is an abstraction layer
for mice and other pointing devices within the
wscons(4) framework. It is
attached to the hardware specific drivers and provides a character device
interface which returns struct wscons_event via
read(2). For use with X
servers, “mouse events” or “touch events” can be
wsmouse driver provides a number of
ioctl functions to control various parameters (see
wsconsctl(8) utility gives
access to these variables.
Touchpad input is processed in one of two modes: In
“absolute mode”, the
generates touch events. Absolute mode is activated by
“compatibility mode”, which is the default,
wsmouse converts the input internally and generates
mouse events. wsconsctl(8)
can query and set several configuration parameters for this mode. The
composite field names have the form
where N is the index of the
wsmouse device. If N is
omitted, commands apply to /dev/wsmouse0.
The unit is percent of the total height of the touchpad surface, or of its total width, respectively. In order to mitigate the effects of accidental touches, the driver ignores most types of input from an edge area (see below). If an edge area contains software buttons, they fill up the space provided.
The automatic configuration enables two-finger scrolling and sets up edge areas at the vertical edges. On clickpads - where the device surface serves as a single, large button - it provides three software button areas at the bottom edge, for left-button, middle-button, and right-button clicks. On some laptops with a trackpoint, the software buttons are at the top edge. Vertical edge scrolling will be enabled on older touchpads that do not report contact counts.
A touch that starts and remains in an edge area does not trigger pointer movement. At the vertical edges and the top edge, tapping and two-finger scrolling require that at least one touch is in the main area of the touchpad (the exact behaviour of a single-touch device depends on its firmware in this case). When multi-touch input is available, a touch is ignored if it rests in the bottom area while there are other inputs - movement, scrolling, or tapping -, and the driver continues to ignore it as long as and whenever other touches are present.
|February 4, 2018||OpenBSD-6.7|