looking glass shell for the OpenBSD
Border Gateway Protocol daemon
bgplgsh program is a looking glass
shell for the bgpd(8) Border Gateway Protocol daemon. The looking glass
will provide a simple command line interface with read-only access to a
restricted set of bgpd(8) and system status information, which is typically
used on route servers by Internet Service Providers (ISPs) and Internet
eXchange points (IXs).
It requires three steps to enable the looking glass shell:
bgplgshas a valid login shell. See shells(5) for more information.
# echo /usr/bin/bgplgsh >> /etc/shells
- Create a new user for restricted looking glass access. See
adduser(8) for more information about system user management.
# adduser -shell bgplgsh -batch bgplg # passwd bgplg
- Start the Border Gateway Protocol daemon with a second, restricted,
control socket. See
bgplg(8) for more information.
For example, add the following to /etc/bgpd.conf to have bgpd(8) open a second, restricted, control socket:
socket "/var/www/run/bgpd.rsock" restricted
- Position of the second, restricted, control socket of bgpd(8).
bgplgsh program first appeared in
OpenBSD 4.1. The initial implementation was done in
2005 for DE-CIX, the German commercial internet exchange point.
bgplgsh program was written by
To prevent commands from running endlessly,
bgplgsh will kill the corresponding processes after
a hard limit of 60 seconds. For example, this can take effect when using
traceroute(8) with blackholed or bad routes.