OpenBSD manual page server

Manual Page Search Parameters

ATU(4) Device Drivers Manual ATU(4)

atuAtmel AT76C50x USB IEEE 802.11b wireless network device

atu* at uhub? port ?

The atu driver provides support for wireless network adapters based around the Atmel AT76C503, AT76C503A, AT76C505, and AT76C505A USB chipsets and four companion radio chipsets.

The atu driver encapsulates all IP and ARP traffic as 802.11 frames, though it can receive either 802.11 or 802.3 frames.

These are the modes the atu driver can operate in:

BSS mode
Also known as mode, this is used when associating with an access point, through which all traffic passes. This mode is the default.
IBSS mode
Also known as mode or mode. This is the standardized method of operating without an access point. Stations associate with a service set. However, actual connections between stations are peer-to-peer.

The atu driver can be configured to use hardware Wired Equivalent Privacy (WEP). It is strongly recommended that WEP not be used as the sole mechanism to secure wireless communication, due to serious weaknesses in it.

The atu driver can be configured at runtime with ifconfig(8) or on boot with hostname.if(5).

The following devices are known to be supported by the atu driver:

3Com 3CRSHEW696
 
AboCom BWU613
 
Accton 2664W
 
Acer Peripherals AWL300
 
Acer Peripherals AWL400
 
Actiontec 802UAT1
 
Addtron AWU120
 
Aincomm AWU2000B
 
Askey Computer Voyager 1010
 
Askey Computer WLL013 (Intersil Radio)
 
Askey Computer WLL013 (RFMD Radio)
 
Atmel AT76C503 (Intersil Radio)
 
Atmel AT76C503 (RFMD Radio)
 
Atmel AT76C505 (RFMD Radio)
 
Atmel AT76C505 (RFMD 2958 Radio)
 
Atmel AT76C505A (RFMD 2958 Radio)
 
Atmel AT76C505AS (RFMD 2958 Radio)
 
Belkin F5D6050
 
Bluetake BW002
 
Compaq iPAQ h54xx/h55xx Internal WLAN
 
Conceptronic C11U
 
Conceptronic WL210
 
Corega WLAN USB Stick 11
 
Dick Smith Electronics CHUSB 611G
 
Dick Smith Electronics WL200U
 
Dick Smith Electronics WL240U
 
Dick Smith Electronics XH1153
 
D-Link DWL-120 rev E
 
Geowave GW-US11S
 
Gigabyte GN-WLBM101
 
Gigaset WLAN
 
Hewlett-Packard HN210W
 
Intel AP310 AnyPoint II
 
I/O DATA USB WN-B11
 
Lexar 2662W-AR
 
Linksys WUSB11 802.11b
 
Linksys WUSB11 802.11b v2.8
 
MSI WLAN
 
Netgear MA101
 
Netgear MA101 rev B
 
OQO model 01 WiFi
 
Ovislink AirLive WL-1120USB
 
OvisLink AirLive WL-1130USB
 
Planex Communications GW-US11S
 
Samsung SWL2100W
 
Siemens WLL013
 
SMC EZ Connect 11Mbps (SMC2662w)
 
SMC EZ Connect 11Mbps v2 (SMC2662wV2)
 
Tekram U-300C
 
TRENDnet TEW-229UB
 
W-Buddie WN210
 
Z-Com M4Y-750
 

The adapter needs some firmware files, which are loaded on demand by the driver when the device is attached:

/etc/firmware/atu-at76c503-i3863-int
 
/etc/firmware/atu-at76c503-i3863-ext
 
/etc/firmware/atu-at76c503-rfmd-acc-int
 
/etc/firmware/atu-at76c503-rfmd-acc-ext
 
/etc/firmware/atu-at76c505-rfmd-int
 
/etc/firmware/atu-at76c505-rfmd-ext
 
/etc/firmware/atu-intersil-int
 
/etc/firmware/atu-intersil-ext
 
/etc/firmware/atu-rfmd-int
 
/etc/firmware/atu-rfmd-ext
 
/etc/firmware/atu-rfmd2958-int
 
/etc/firmware/atu-rfmd2958-ext
 
/etc/firmware/atu-rfmd2958smc-int
 
/etc/firmware/atu-rfmd2958smc-ext
 

The following example scans for available networks:

# ifconfig atu0 scan

The following hostname.if(5) example configures atu0 to join network “mynwid”, using WEP key “mywepkey”, obtaining an IP address using DHCP:

nwid mynwid
nwkey mywepkey
dhcp

arp(4), ifmedia(4), intro(4), netintro(4), usb(4), hostname.if(5), ifconfig(8)

The atu driver was written by Daan Vreeken and ported to OpenBSD by Theo de Raadt and David Gwynne.

The atu driver does not support a lot of the functionality available in the hardware. More work is required to properly support the IBSS, power management, and selectable transmission rate features.

October 19, 2013 OpenBSD-6.3