OpenBSD manual page server

Manual Page Search Parameters

DHCRELAY(8) System Manager's Manual DHCRELAY(8)

dhcrelayDynamic Host Configuration Protocol relay agent

dhcrelay [-dor] [-C circuit-id] [-R remote-id] -i interface destination ...

The dhcrelay utility provides a means for relaying DHCP and BOOTP requests from a subnet to which no DHCP server is directly connected to one or more DHCP servers on other subnets.

dhcrelay listens for DHCP requests on a given interface. When a query is received, dhcrelay forwards it to the list of DHCP destinations specified on the command line. When a reply is received, it is broadcast or unicast on the network from whence the original request came.

The server might be a name, address or interface. dhcrelay will operate in layer 2 mode when the specified servers are interfaces, otherwise it will operate in layer 3 mode.

The name of at least one DHCP server to which DHCP and BOOTP requests should be relayed, as well as the name of the network interface that dhcrelay should attempt to configure, must be specified on the command line.

dhcrelay supports relaying of DHCP traffic to configure IPsec tunnel mode clients when listening on the enc(4) interface using layer 3 mode only. The DHCP server has to support RFC 3046 to echo back the relay agent information to allow stateless DHCP reply to IPsec tunnel mapping.

The options are as follows:

circuit-id
The circuit-id relay agent information sub-option value that dhcrelay should append on relayed packets. If this option is not specified it will use the interface number by default.
Do not daemonize. If this option is specified, dhcrelay will run in the foreground and log to .
interface
The name of the network interface that dhcrelay should attempt to configure. For layer 3 mode at least one IPv4 address has to be configured on this interface.
Add the relay agent information option. By default, this is only enabled for the enc(4) interface.
remote-id
The remote-id relay agent information sub-option value that dhcrelay should append on relayed packets. If this option is not specified it will use the destination address by default.
Replace incoming Relay Agent Information with the one configured.

dhclient(8), dhcpd(8)

R. Droms, Dynamic Host Configuration Protocol, RFC 2131, March 1997.

S. Alexander and R. Droms, DHCP Options and BOOTP Vendor Extensions, RFC 2132, March 1997.

M. Patrick, DHCP Relay Agent Information Option, RFC 3046, January 2001.

B. Patel, B. Aboba, S. Kelly, and V. Gupta, Dynamic Host Configuration Protocol (DHCPv4) Configuration of IPsec Tunnel Mode, RFC 3456, January 2003.

dhcrelay was written by Ted Lemon <mellon@fugue.com>.

The current implementation was reworked by Henning Brauer <henning@openbsd.org>.

Relayed DHCP traffic could actually safely be protected by IPsec but, like dhcpd(8) and dhclient(8), dhcrelay will bypass IPsec for all its traffic.

February 15, 2017 OpenBSD-6.2