pseudo-random number generator;
routines for changing generators
int seed, char
To satisfy portable code,
may be called to initialize the subsystem. In
OpenBSD the seed variable is
ignored, and strong random number results will be provided from
arc4random(3). In other systems, the
seed variable primes a simplistic deterministic
If the standardized behavior is
can be substituted for
srandom(), then subsequent
random() calls will return results using the
In non-deterministic (default) mode, the
function returns results from
arc4random(3) in the range from 0 to (2**31)-1.
In deterministic mode, the
function uses a non-linear additive feedback random number generator
employing a default table of size 31 long integers to return successive
pseudo-random numbers in the range from 0 to (2**31)-1. The period of this
random number generator is very large, approximately 16*((2**31)-1), but the
results are a deterministic sequence from the seed.
routine allows a state array, passed in as an argument, to be initialized
for future use. The size of the state array (in bytes) is used by
initstate() to decide how sophisticated a random
number generator it should use — the more state, the better the
random numbers will be. (Current "optimal" values for the amount
of state information are 8, 32, 64, 128, and 256 bytes; other amounts will
be rounded down to the nearest known amount. Using less than 8 bytes will
cause an error.) The seed for the initialization (which specifies a starting
point for the random number sequence, and provides for restarting at the
same point) is also an argument. The
function returns a pointer to the previous state information array.
Once a state has been initialized, the
routine provides for rapid switching between states. The
setstate() function returns a pointer to the
previous state array; its argument state array is used for further random
number generation until the next call to
Once a state array has been initialized, it may
be restarted at a different point either by calling
(with the desired seed, the state array, and its size) or by calling both
setstate() (with the state array) and
srandom() (with the desired seed). The advantage of
srandom() is that the size of the state array does
not have to be remembered after it is initialized.
forces the subsystem into deterministic mode.
initstate() is called with less than 8
bytes of state information, or if
that the state information has been garbled, error messages are printed on
the standard error output.
arc4random(3), drand48(3), rand(3), random(4)
functions conform to X/Open Portability Guide
Issue 4, Version 2 (“XPG4.2”).
srandom() function does not conform to
X/Open Portability Guide Issue 4, Version 2
srandomdev() function is an
srandom_deterministic() function is an
These functions appeared in 4.2BSD.
Earl T. Cohen