OpenBSD manual page server

Manual Page Search Parameters

RT(4) Device Drivers Manual RT(4)

rtAIMS Lab Radiotrack FM radio device

rt0 at isa? port 0x30c
rt1 at isa? port 0x20c
rt* at isapnp?
radio* at rt?

The rt driver provides support for the AIMS Lab Radiotrack FM radio tuners and compatible - RadioReveal RA300 FM radio tuners and tuners at SoundForte RadioX SF16-FMI (Creative ViBRA16C PnP).

The Radiotrack is a stereo FM tuner that can tune in the range 87.5 - 108.0 MHz, report signal status on the current frequency, and force audio output to mono.

The card is based on the LM7000 chip; see radio(4) for details.

The Radiotrack cards take only one I/O port. The I/O port is set by the driver to the value specified in the configuration file and must be either 0x20c or 0x30c.

intro(4), isa(4), isapnp(4), radio(4), radio(9)

The rt device driver appeared in OpenBSD 3.0.

The rt driver was written by Vladimir Popov <jumbo@narod.ru> and Maxim Tsyplakov <tm@oganer.net>. The man page was written by Vladimir Popov <jumbo@narod.ru>.

Support for the SF16-FMI cards is rather ugly, the driver cannot determine signal state and force audio output to mono.

It is impossible to determine which frequency the card is tuned to. Thus, the driver will report an internally stored value even if it is not correct (e.g. tuning was done through the direct I/O access).

November 1, 2015 OpenBSD-5.9