and Intel GDT SATA/SCSI RAID controller
gdt* at pci?
driver provides support for ICP-Vortex
adapters such as:
GDT4x13RZ, GDT4x23RZ, GDT6000/6020/6050, GDT6000B/6010, GDT6110/6510,
GDT6120/6520, GDT6513RS, GDT6518RS, GDT6523RS, GDT6530, GDT6535, GDT6537,
GDT6537RP, GDT6537RP1, GDT6537RP2, GDT6550, GDT6555, GDT6557, GDT6557RP,
GDT6557RP1, GDT6557RP2, GDT6x11RP, GDT6x11RP1, GDT6x11RP2, GDT6x15, GDT6x17,
GDT6x17RP, GDT6x17RP1, GDT6x17RP2, GDT6x18RD, GDT6x19RD, GDT6x21RP,
GDT6x21RP1, GDT6x21RP2, GDT6x25, GDT6x27, GDT6x27RP, GDT6x27RP1, GDT6x27RP2,
GDT6x28RD, GDT6x28RS, GDT6x29RD, GDT6x33RS, GDT6x38RD, GDT6x38RS, GDT6x43RS,
GDT6x53RS, GDT6x58RD, GDT6x58RS, GDT6x63RS, GDT7x13RN, GDT7x18RN, GDT7x19RN,
GDT7x23RN, GDT7x28RN, GDT7x29RN, GDT7x38RN, GDT7x43RN, GDT7x53RN, GDT7x58RN,
GDT7x63RN, GDT8x00RZ, GDT8x13RZ, GDT8x14RZ, GDT8x22RZ, GDT8x23RZ, GDT8x23RZ,
GDT8x24RZ, GDT8x33RZ, GDT8x43RZ, GDT8x46RZ, GDT8x53RZ, GDT8x63RZ, and
As well as Intel adapters such as:
SRCU42L, SRCU32, SRCZCR, and SRCS14L.
Although the controllers are actual RAID controllers, the driver makes them look
just like SCSI controllers. All RAID configuration is done through the
- pci_mem_find: expected mem type
00000000, found 00000002
- This message occurs during autoconfiguration if jumper J4
is set to map the controller memory below 1MB in physical memory. The
driver primarily wants this jumper to be set the other way round, but it
will work with it in any setting. If the diagnostic is considered a
nuisance, alter jumper J4's setting.
driver first appeared in
driver was written by
inspired by the Linux driver by Achim
An ISA & EISA front-end is needed.
The driver does not support transparent raw SCSI mode.
It would be nice to configure the RAID units after boot but the information on
how to do that is not public.