OpenBSD manual page server

Manual Page Search Parameters

BOOT_ZAURUS(8) System Manager's Manual (zaurus) BOOT_ZAURUS(8)

boot_zauruszaurus system bootstrapping procedures

When powered on, or if the system is rebooted via reboot(8) or shutdown(8), the processor begins executing code at physical address 0. The early startup code is preinstalled by the manufacturer, and will load a minimal UNIX-like operating system from internal flash memory (our primary bootstrap loader, for now).

On most systems, booting OpenBSD from the primary bootstrap loader will eventually load the OpenBSD-specific zaurus bootstrapping code. This versatile program is described in a separate document, boot(8).

In case of system crashes, the kernel will usually enter the kernel debugger, ddb(4), unless it is not present in the kernel, or it is disabled via the sysctl. Upon leaving ddb, or if ddb was not entered, the kernel will halt the system if it was still in device configuration phase, or attempt a dump to the configured dump device, if possible. The crash dump will then be recovered by savecore(8) during the next multi-user boot cycle. It is also possible to force other behaviours from ddb.

/bsd
default system kernel
/bsd.rd
standalone installation kernel, suitable for disaster recovery
/usr/mdec/zboot
system bootstrap
/usr/mdec/zbsdmod.o
kernel module for the primary bootstrap loader that must be loaded before the system bootstrap

ddb(4), boot(8), halt(8), init(8), reboot(8), savecore(8), shutdown(8)

May 31, 2007 OpenBSD-5.6