OpenBSD manual page server

Manual Page Search Parameters

DCA(4) Device Drivers Manual (hp300) DCA(4)

dcaHP 98644A serial communications interface

dca0 at dio? scode 9 flags 1 (on-board serial interfaces)
dca* at dio?

The 98644A is a single port EIA RS-232C (CCITT V.28) communications interface with a single character buffer. Such an interface is built-in to all series 300 machines.

Input and output for each line may be set to one of the following baud rates: 50, 75, 110, 134.5, 150, 300, 600, 1200, 1800, 2400, 4800, 9600, 19200, 38400.

An optional argument flags may be set to 1 if the line should be treated as hard-wired with carrier always present or 0 if modem control is desired.

/dev/tty[0-3]
 
/dev/cua[0-3]
 

dca0: silo overflow.
The single-character input “silo” has overflowed and incoming data has been lost.

dio(4), intro(4), tty(4)

Data loss is possible on busy systems with baud rates greater than 300. The dca has never been tested with modem control enabled or on anything but the built-in interface.

June 2, 2013 OpenBSD-5.4