|URAL(4)||Device Drivers Manual||URAL(4)|
ural* at uhub? port ?
uraldriver supports USB 2.0 wireless adapters based on the Ralink RT2500USB chipset.
The RT2500USB chipset is the first generation of 802.11b/g adapters from Ralink. It consists of two integrated chips, an RT2570 MAC/BBP and an RT2526 radio transceiver.
These are the modes the
ural driver can
ural driver can be configured to use
Wired Equivalent Privacy (WEP) or Wi-Fi Protected Access (WPA-PSK and
WPA2-PSK). WPA is the de facto encryption standard for wireless networks. It
is strongly recommended that WEP not be used as the sole mechanism to secure
wireless communication, due to serious weaknesses in it. The
ural driver relies on the software 802.11 stack for
both encryption and decryption of data frames.
The transmit speed is user-selectable or can be adapted automatically by the driver depending on the number of hardware transmission retries.
dhcp NONE NONE NONE nwkey 0x1deadbeef1 chan 11
The following hostname.if(5) example creates a host-based access point on boot:
inet 192.168.1.1 255.255.255.0 NONE media autoselect \ mediaopt hostap nwid my_net chan 11
Configure ural0 to join network “my_net” using WPA with passphrase “my_passphrase”:
# ifconfig ural0 nwid my_net wpakey my_passphrase
Join an existing BSS network, “my_net”:
# ifconfig ural0 192.168.1.1 netmask 0xffffff00 nwid my_net
Ralink Technology: http://www.ralinktech.com/
uraldriver first appeared in OpenBSD 3.7.
uraldriver was written by Damien Bergamini ⟨email@example.com⟩.
uraldriver supports automatic control of the transmit speed in BSS mode only. Therefore the use of an
uraladapter in Host AP mode is discouraged.
Host AP mode doesn't support power saving. Clients attempting to use power saving mode may experience significant packet loss (disabling power saving on the client will fix this).
|November 1, 2010||OpenBSD-5.1|