NAME
atapiscsi
—
ATAPI<->SCSI adapter
SYNOPSIS
atapiscsi* at wdc? flags 0x0000
atapiscsi* at pciide? flags 0x0000
scsibus* at atapiscsi?
DESCRIPTION
The atapiscsi
driver supports ATAPI (also
called IDE) devices such as CD-ROMs, ZIP drives, LS-120 floppy drives, and
tape drives. All ATAPI devices talk a subset of the SCSI protocol.
The atapiscsi
driver acts like a SCSI
adapter. Thus, the ATAPI devices connected to the system will appear as SCSI
devices. ATAPI CD-ROMs will appear as
cd(4)
devices, ATAPI tape drives as
st(4)
devices, and ATAPI floppies as
sd(4)
devices.
For performance reasons, one should avoid putting an ATAPI device and a hard disk on the same cable. The driver does not support bus release and, even if it did, many ATAPI devices do not support it. There is only one command outstanding on a cable at a time. For example, if a hard disk and a CD drive are placed on the same cable, the hard disk requests may get queued behind slower CD operations.
The flags
are used only with controllers
that support DMA operations and mode settings (like some
pciide(4) controllers). The lowest order (rightmost) nibble of the
flags
define the PIO mode to use. The next four bits
indicate the DMA mode and the third nibble the UltraDMA mode.
For each set of four bits, the 3 lower bits define the mode to use
and the last bit must be set to 1 for this setting to be used. For DMA and
UltraDMA, 0xf (1111) means “disable”. For example, a
flags
value of 0x0fac (1111 1010 1100) means
“use PIO mode 4, DMA mode 2, disable UltraDMA”. The special
setting 0x0000 means “use whatever the drive claims to
support”.
SEE ALSO
BUGS
Slow devices, like tape drives, could do a better job of sharing the channel. For now, we recommend you put the tape device on its own channel.