OpenBSD manual page server

Manual Page Search Parameters
INTRO(4) Device Drivers Manual (sparc64) INTRO(4)

introintroduction to special files and hardware support

The manual pages in section 4 describe the special files, related driver functions, and networking support available in the system. In this part of the manual, the SYNOPSIS section of each configurable device gives a sample specification for use in constructing a system description for the config(8) program. The DIAGNOSTICS section lists messages which may appear on the console and/or in the system error log /var/log/messages due to errors in device operation; see syslogd(8) for more information.

This section contains both devices which may be configured into the system and network related information. The networking support is introduced in netintro(4).

This section describes the hardware supported on the sparc64 platform. Software support for these devices comes in two forms. A hardware device may be supported with a character or block , or it may be used within the networking subsystem and have a . Block and character devices are accessed through files in the file system of a special type; see mknod(8). Network interfaces are indirectly accessed through the interprocess communication facilities provided by the system; see socket(2).

A hardware device is identified to the system at configuration time and the appropriate device or network interface driver is then compiled into the system. When the resultant system is booted, the autoconfiguration facilities in the system probe for the device and, if found, enable the software support for it. If a device does not respond at autoconfiguration time it is not accessible at any time afterwards. To enable a device which did not autoconfigure, the system will have to be rebooted.

The autoconfiguration system is described in autoconf(4).

A complete list of available devices is contained within the pages describing the system buses and controllers. For example, a PCI device would be listed in the pci(4) man page. The following buses and controllers list these devices:

ebus(4)
introduction to SPARC EBus bus support
iic(4)
Inter IC (I2C) bus
onewire(4)
1-Wire bus
pci(4)
introduction to PCI bus support
pcmcia(4)
introduction to PCMCIA (PC Card) support
sbus(4)
introduction to SBus bus support
usb(4)
introduction to Universal Serial Bus support
vbus(4)
virtual device bus

autoconf(4), config(8)

The sparc64 intro first appeared in OpenBSD 3.0.

March 9, 2008 OpenBSD-5.1