OpenBSD manual page server

Manual Page Search Parameters

MIXERCTL.CONF(5) File Formats Manual MIXERCTL.CONF(5)

mixerctl.confmixerctl configuration file

mixerctl.conf is the configuration file for mixerctl(8). It allows the user to specify settings for the audio mixer at system startup. The exact set of variables available are largely dependent on the audio device driver, and vary from device to device. The file is made up of variable assignments (name=value) with comments designated by a hash mark (‘#’).

Some audio devices have _sense variables which can help identify connectors. The connectors' state will be one of plugged or unplugged, depending on whether a jack is inserted.

The connectors on audio cards are generally as follows:

pink
Microphone in. Used to record from a microphone.
green
Line out. Used for stereo speakers or headphones.
blue
Line in. Used to record from an external source.
orange
Speaker out; subwoofer.
brown
Speaker out; rear speakers.
S/PDIF
Optical connector; TOSLink, RCA, or 1/8" mini stereo.

Most devices have a number of digital to analogue converters (DACs), used for sound playback, and each DAC has a corresponding output mixer. The mixers are labelled “mix” or “sel”. Each DAC represents two channels of playback.

Verify that playback works by playing an audio file (see aucat(1)) or CD (see cdio(1)). Check that any relevant inputs.* variables are unmuted and set to a high enough value to permit playback. For example, if playing a CD, grep(1) for cd variables to adjust. Check also that the variable governing the general audio level, such as outputs.master, is set to a sufficiently high value.

Some cards are capable of multi-channel sound. In some cases _dir variables detail the direction (input or output) of the various connectors. Check that the direction of the corresponding connectors is set to output. Other devices may need to set _source variables to work correctly. The maximum possible value of the audioctl(8) variable play.channels shows the number of channels available.

Most devices have a number of analogue to digital converters (ADCs), used for recording sound, and each ADC has a corresponding input mixer. The mixers are labelled “mix” or “sel”. Each ADC represents two channels of recording.

Connect line in on the audio card to an audio source, such as an amplifier. Many devices have an auxiliary connector (“aux”) available for recording, or a headphone socket could be used.

Check that the variable that determines recording volume, such as record.volume, is set high enough to provide a high enough sound level, but not so high as to distort the sound being recorded. It is also a good idea to mute any record.* variables not being used for recording. Obviously the recording source itself will have to be unmuted.

A simple test that recording works may be done using aucat(1) whilst playing back audio from an external source. The example below creates a .wav file of any audio being played. The file can then be played back to determine quality.

$ aucat -o test.wav

/dev/audioctl0
Default audio mixing device.
/etc/mixerctl.conf
mixerctl(8) configuration file.
/etc/examples/mixerctl.conf
Example configuration file.

aucat(1), audioctl(8), mixerctl(8)

April 21, 2020 OpenBSD-7.1