|INET_NTOP(3)||Library Functions Manual||INET_NTOP(3)|
const char *
af, const void * restrict
src, char * restrict
af, const char * restrict
src, void * restrict
inet_pton() function converts a presentation format address (that is, printable form as held in a character string) to network format (usually a
struct in_addror some other internal binary representation, in network byte order). It returns 1 if the address was valid for the specified address family; 0 if the address wasn't parseable in the specified address family; or -1 if some system error occurred (in which case errno will have been set). This function is presently valid for
inet_ntop() converts an
address from network format to presentation format. It returns
NULL if a system error occurs (in which case,
errno will have been set), or it returns a pointer to
the destination string.
All Internet addresses are returned in network order (bytes ordered from left to right).
All four parts must be decimal numbers between 0 and 255,
inclusive, and are assigned, from left to right, to the four bytes of an
Internet address. Note that when an Internet address is viewed as a 32-bit
integer quantity on a system that uses little-endian byte order (such as the
Intel 386, 486 and Pentium processors) the bytes referred to above appear as
d.c.b.a”. That is, little-endian
bytes are ordered from right to left.
The presentation format of an IPv6 address is given in RFC 4291:
There are three conventional forms for representing IPv6 addresses as text strings:
Note that it is not necessary to write the leading zeros in an individual field, but there must be at least one numeral in every field (except for the case described in 2.).
For example the following addresses:
1080:0:0:0:8:800:200C:417A a unicast address FF01:0:0:0:0:0:0:43 a multicast address 0:0:0:0:0:0:0:1 the loopback address 0:0:0:0:0:0:0:0 the unspecified addresses
may be represented as:
1080::8:800:200C:417A a unicast address FF01::43 a multicast address ::1 the loopback address :: the unspecified addresses
or in compressed form:
inet_ptonfunctions conform to the IETF IPv6 BSD API and address formatting specifications, as well as IEEE Std 1003.1-2008 (“POSIX.1”).
inet_ntopfunctions appeared in BIND 4.9.4.
inet_ptondoes not accept 1-, 2-, or 3-part dotted addresses; all four parts must be specified and must be in decimal (and not octal or hexadecimal). This is a narrower input set than that accepted by
R. Gilligan, S. Thomson, J. Bound, J. McCann, and W. Stevens, Basic Socket Interface Extensions for IPv6, RFC 3493, February 2003.
R. Hinden and S. Deering, IP Version 6 Addressing Architecture, RFC 4291, February 2006.
|May 9, 2014||OpenBSD-6.1|