OpenBSD manual page server

NAME

rbootd — HP remote boot server

SYNOPSIS

DESCRIPTION

The rbootd utility services boot requests from Hewlett-Packard workstations over a local area network. All boot files must reside in the boot file directory; further, if a client supplies path information in its boot request, it will be silently stripped away before processing. By default, rbootd only responds to requests from machines listed in its configuration file.

The options are as follows:

-a

Respond to boot requests from any machine. The configuration file is ignored if this option is specified.

-d

Run rbootd in debug mode. Packets sent and received are displayed to the terminal.

-i interface

Service boot requests on specified interface. If unspecified, rbootd searches the system interface list for the lowest numbered, configured “up” interface (excluding loopback). Ties are broken by choosing the earliest match.

Specifying config_file on the command line causes rbootd to use a different configuration file from the default.

The configuration file is a text file where each line describes a particular machine. A line must start with a machine's Ethernet address followed by an optional list of boot file names. An Ethernet address is specified in hexadecimal with each of its six octets separated by a colon. The boot file names come from the boot file directory. The Ethernet address and boot file(s) must be separated by whitespace and/or comma characters. A pound sign causes the remainder of a line to be ignored.

Here is a sample configuration file:

#
# Ethernet addr		boot file(s)		comments
#
08:00:09:0:66:ad	SYSHPBSD		# snake (4.3BSD)
08:00:09:0:59:5b				# vandy (anything)
8::9:1:C6:75		SYSHPBSD,SYSHPUX	# jaguar (either)

rbootd logs status and error messages via syslog(3). A startup message is always logged, and in the case of fatal errors (or deadly signals) a message is logged announcing the server's termination. In general, a non-fatal error is handled by ignoring the event that caused it (e.g., an invalid Ethernet address in the config file causes that line to be invalidated).

The following signals have the specified effect when sent to the server process using the kill(1) command:

FILES

/dev/bpf#

packet-filter device

/etc/rbootd.conf

configuration file

/tmp/rbootd.dbg

debug output

/usr/mdec/rbootd

directory containing boot files

SEE ALSO

kill(1), socket(2), signal(3), syslog(3)

BUGS

If multiple servers are started on the same interface, each will receive and respond to the same boot packets.