OpenBSD manual page server

Manual Page Search Parameters

NOHUP(1) General Commands Manual NOHUP(1)

nohupinvoke a command immune to hangups

nohup utility [arg ...]

The nohup command allows the specified utility to be protected from termination if the user should become logged out (for example, due to a modem line or TCP/IP connection being dropped). To do this, nohup sets the SIGHUP signal(3) (“terminal line hangup”) to be ignored, then executes utility along with any arguments.

If the standard output is a terminal, the standard output is appended to the file nohup.out in the current directory. If standard error is a terminal, it is directed to the same place as the standard output.

If the output file nohup.out cannot be created in the current directory, nohup attempts to create the file in the user's home directory. If the file nohup.out cannot be created, either in the current directory or the user's home directory, nohup will exit without invoking utility, with an exit value as described below.

User's home directory.

The nohup utility exits with one of the following values:

126
The utility was found but could not be invoked.
127
The utility could not be found or an error occurred in nohup.

Otherwise, the exit status of nohup shall be that of utility.

csh(1), signal(3)

The nohup utility is compliant with the IEEE Std 1003.1-2008 (“POSIX.1”) specification.

nohup also exists as a built-in to csh(1), though with a different syntax.

September 29, 2010 OpenBSD-current